Description
DIY 3D print:
File: iddqd.dk/fw/rfexplorer_holder.zip (right click -> save as)
Print instructions:
– Prints without supports, holder standing up, plate laying flat
– Print with 100% infill, why not
– For the plate with the embedded 1/4″ nut, you will have to pause the print and insert the nut at the right layer
Hardware needed:
1 x locking 1/4″-20 UNC nut. The one I used for this design is 7.7 mm K (height)
4 x threaded M3 brass heat inserts. The ones I used for this design is 5.6 mm K (height)
If you enjoy this free 3D file, you can support me by telling your sound friends about my website or leave a tip
